G9SP-N10S Manual OMRON SERVOMOTORS/SERVO DRIVES G9SP-N10S User's Manual

Terminal (Wire connection): Screw terminal.
Classification: Microloads.
Latching lever (Test switch): No.
Rated input voltage: AC/DC, 24V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel OMRON SERVOMOTORS/SERVO DRIVES User's Manual.
Realized opening and closing ability with one pole 6 A slim shape G9SP-N10S
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location).
Screw terminal is also stocked to meet the screw type needs OMRON SERVOMOTORS/SERVO DRIVES User's Manual.
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Terminals: Push-In Plus terminal blocks.
Type: Output *2.
Points: 16.
Internal I/O circuit common: NPN (+ common).
Rated voltage: 24 VDC.
I/O Relay Terminals with 16 Points and,
Push-In Plus terminal blocks to,
Downsize Control Panels and Save Labor.
I/O Relay Terminals with 16 points to mount G2RV Slim I/O Relays OMRON SERVOMOTORS/SERVO DRIVES User's Manual.
Push-In Plus terminal blocks are used to save wiring work in,
comparison with traditional screw terminals. (Wiring time is,
reduced by 60%* in comparison with traditional screw terminals G9SP-N10S User's Manual. ).
Work is reduced ever further with one-step cable connection to the PLC.
Diode provided for coil surge absorption G9SP-N10S User's Manual.
Operation indicators for immediate recognition of I/O signal status.
Accepts G3RV Slim I/O SSRs.
DIN Track or screw mounting. Analog I/O terminal with screw terminal,
block for EtherCAT communicaitons.
The input/output range can be easily,
changed by the setting with the switch G9SP-N10S User's Manual.
Detachable screw terminal block,
facilitates the maintenance.
Moving average calculation function.
Settings within tthe range of 100μs-64ms G9SP-N10S Manual.
(For input only.)
Disconnection detection function.
(For input only and for usage with,
1-5V or 4-20mA ranges.)
Selectable node address setting methods:
setting with rotary,

switch and with tool software OMRON SERVOMOTORS/SERVO DRIVES User's Manual.
When setting the nodes with rotary switch,
setting is easy and node identification,
becomes possible for maintenance.