G9SX-LM224-F10-RC Manual OMRON SYSMAC G9SX-LM224-F10-RC USER'S MANUAL

Unique Ratchet Mechanism Assures Positive.
Alternate Transfer/Switching Operation.
Each contact in the double-pole contact mechanism performs.
alternate make-brake operation at each pulse input and is thus.
ideal for alternate operation or transfer/switching operation of a motor.
Positive operation is assured due to the unique ratchet mecha nism OMRON SYSMAC USER'S MANUAL.
Satisfies dielectric strength of 2,000 VAC G9SX-LM224-F10-RC
Low power consumption.
(AC: approx. 6.4 VA; DC: approx. 3.9 W). Category: relay output.
Points: 8 points (1a * 8).
Common line processing on the connector side: NPN correspondence (+ public).
Rated voltage: DC24V.
Achieve control cabinet miniaturization / save time,
Relay terminal for 8 point output OMRON SYSMAC USER'S MANUAL.
Small size of 68 * high 80 * 44mm. (vertical installation)
Total wiring of connector cable.
The common end can be easily connected with the independent contact and the short circuit piece.
The G70D-SOC08 and G70R-SOC08 are connected by a short circuit chip.
When the relay does not need the tool, the relay is convenient to replace the work.
With terminal cover to prevent electric shock.
With action indication LED OMRON SYSMAC USER'S MANUAL.
Diode for internal coil surge absorption.
DIN guide rail installation, screw mounting common. Type: input module.
Insulation: photo coupler.
Action indicator: there.
Logic supply voltage: DC4 ~ 32V.
Logic supply current: 25mA G9SX-LM224-F10-RC USER'S MANUAL.
Input rated voltage: DC5 ~ 24V.
I/O solid state relay can be used for OMRON I/O type G7TC relay terminal.
Input and output composite input module, the output module is complete G9SX-LM224-F10-RC USER'S MANUAL.
Can be used for I/O type P7TF terminal. Can also be mixed with the I/O type G7T relay.
Can check the working status of SSR through the action indicator.
Have access to UL, CSA standard certification of the series of products have also been series (-US type)Control terminal block: Terminal block with small slotted screws G9SX-LM224-F10-RC USER'S MANUAL.
Type: Standard.
Capacity: 20 A, 100 to 240 VAC.
Heater burnout detection: No.
Communications: No.
High-precision Control with Easy Setup,
Precise heater burnout detection.
Set value and present value monitoring with indicators.
Phase control or optimum cycle control.
RS-4885 communications to set manipulated variables and,
monitor load current G9SX-LM224-F10-RC Manual.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,,
and constant-current control OMRON SYSMAC USER'S MANUAL.
Application with various loads: constant load resistance,
variable load resistance.
UL, and IEC/EN (TÜV) certified.