OMRON E5CC-QX0DUM-000 Manual E5CC-QX0DUM-000 RS-485 CompoWay/F INSTRUCTION MANUAL

Size: 96 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: position ratio control.
Auxiliary output points: 2 points.
Event entry point: 4.
Transfer output: transfer output (special terminal) E5CC-QX0DUM-000 INSTRUCTION MANUAL.
Remote SP:4 to 20mA input.
Communication: - E5CC-QX0DUM-000
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved.
High resolution 5 bit display / can display 0 E5CC-QX0DUM-000 INSTRUCTION MANUAL. 01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV.
By supporting software (Ver.4 E5CC-QX0DUM-000 INSTRUCTION MANUAL. 0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type. Size: M8, Non-shielded.
Sensing distance: 4.0 mm.
Connection: M8 connector (3-pin).
Body material: Stainless steel.
Thread length (overall length): 27 (39).
Output configuration: PNP.
Operation mode NO.
Safe Mounting with Greater.
Sensing Distance.
Ensures a sensing distance approximately 1.5 to 2,
times larger than that of any conventional OMRON Sensor.
Problems such as the collision of workpieces are eliminated.
Full range of standard sizes (M8, M12, M18 and,
M30; both long and short barrels).
Modular construction simplifies customization. Sensing method: Narrow-beam reflective.
Connection method: Connector (M8, 4pins).
Sensing distance: 90±30 mm.
Model: PNP output.
Small 2.5-mmm-diameter Spot Ideal for E5CC-QX0DUM-000 Manual.
Detecting Small Workpieces.
Tiny workpieces as little as 0.1 mm in diameter can be,
detected with the 2.5-mm-dia. spot.
The narrow beam enables sensing from small slots or holes.
The small spott of light enables visual checking of sensing,
spot position E5CC-QX0DUM-000 Manual.
IP67 degree of protection, mutual interference prevention,
and EN standard compliance.