OMRON E5CN-HTQ2HH03D-FLK User's Manual E5CN-HTQ2HH03D-FLK Communications Functions Manual

Appearance: Close-mounting.
Sensing method: Through beam type (with slot).
Connecting method: Connector model (4 poles).
Sensing distance: 5 mm (slot width).
Operating mode: Dark-ON/Light-ON (2 outputs).
Indicator mode: Incident light.
Model: PNP output.
Built-in connector enables,
downsizing and easier connection E5CN-HTQ2HH03D-FLK User's Manual.
Protective circuit for safe operation.
A built-in connector minimizes the shape and dimensional,
requirements E5CN-HTQ2HH03D-FLK
Two outputs: light-ON and dark-ON.
Complete lineup including seven different shapes.
Safer operation with built-in power supply reverse polarity,
protection.
Output overcurrent protection with a thermal shutdown,
circuit (patent pending).
The indicator can be seen from many directions to enable,
installation in more locations E5CN-HTQ2HH03D-FLK User's Manual.
Connector with lock that mates with commercially available,
connectors. Size: 48 * 48mm, terminal type.
Type: control output 1 point type (power AC/DC24V).
Shell color: black.
Control output: voltage output (SSR driver).
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function E5CN-HTQ2HH03D-FLK User's Manual.
Event entry point: 2.
Transfer output: -.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can perform flexible contact output.
The controol output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller E5CN-HTQ2HH03D-FLK Manual. Sensing method: Diffuse-reflective Sensors.
Appearance: Horizontal.
Connection method: Pre-wired.
Sensinng distance: 100 mm (wide view) E5CN-HTQ2HH03D-FLK Manual.
Functions: Timer Self Diagnosis.
Model: PNP output.
Ordering Information.
Built-in Amplifier Photoelectric Sensors.