OMRON K3HB-HTA-1 User's Manual

Input type: PNP input type.
Event input terminal 5 points (S-TMR, HOLD, RESET) is equipped with.
External power 80mA DC12V.
Note: K3HB-RPB-A, K3HB-RNB-A is not equipped with event input.
Communication: RS-232C; NPN open collector (HH, H, PASS, L, LL).
96 (W) * 48 (H * 95mm) depth.
Power supply voltage: AC/DC24V K3HB-HTA-1 .
Digital rotating pulse meter with high speed measurement for 50kHz K3HB-HTA-1
Action determine the color, can switch the green / Red 2 kinds of color display.
Measurement of 50kHz high speed pulse.
Can rotate the encoder and a variety of ON/OFF pulse signal, up to 50kHzTime specification: Inverse type.
Current setting range: 50 to 160 A.
Operating voltage: 400/440 VAC.
Resetting method: Manual K3HB-HTA-1 .
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation K3HB-HTA-1 .
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, and load conditions. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
before using the K2CM. Product: Flexible Tube Nozzle; 100 mm.
Wide Range of Nozzles for Optimal.
Ionization.
A wide range of nozzle variations.
High-frequency AC method with excellent ion balance. Measure High-speed Up/down Pulses with this.
Up/down Pulse Meter.
Visual conf0rmation of judgement results through display colors that,
switch between red and green.
Perfect for Measuring Rotary Encoder and ON/OFF Pulse Signals at High Speed,
Cumulative pullse input is 50 kHz, quadrature pulse inputs are 25 kHz,
and up/down pulse inputs are 30 kHz K3HB-HTA-1 User's Manual.
Note: No-voltage contacts of up to 30 Hz are supported.
The count value can be converted to any value.
The length equivalent ffor any pulse can be set to any desired value K3HB-HTA-1 User's Manual. This is,
effective for feed amount and position monitor displays.
DeviceNet models added to the series.