Programmable Terminals CVM1-CLK12 (H-PCF CABLE) Manual OMRON CVM1-CLK12 (H-PCF CABLE) Installation Guide

Specification: Thermocouple input (K, J, L, T, R, S, B),
ON/OFF or advanced PID control,
manual op-eration,
transistor (NPN) output, 4 loops.Name: Repeater Unit.
Specifications: A sub-trunk line can be,
connected downstream,
(for trunk-branch line configuration),
or further branching is enabled downstream,
(for configurations with no wiring restrictions),
in the same way as for a Master Unit CVM1-CLK12 (H-PCF CABLE) Manual CVM1-CLK12 (H-PCF CABLE)
A Repeater Unit can be used to branch,
the trunk line and increase the,
number of connected Units,
as well as to extend the length of the,
communications line.
Standards: CE, U, U1, L, N.
Simple and Intelligent Bit Slaves,
with Industry-standard e-CON connectors.
Slave Units capable of 2-point bit-level distribution CVM1-CLK12 (H-PCF CABLE) Manual.
The I/O power supply is supplied from the communications,
power in the previously connected flat cable, and has a,
short-circuit detection function for protection.
Industry-standard e-CON connectors.
Short-circuit protection safeguards the network,
from I/O short circuits.
Simple communications connections,
with flat cable and connectors.
Bit-level distribution to support,
essentially any application CVM1-CLK12 (H-PCF CABLE) Manual. Model: C200H-ID218.
No. of points: 32 pts.
Specifications: 24 VDC.
Weight: 180g max.Model : CV500-CN228.
BASIC for connecting the unit ← → FIT10 (2m).Programmed using the Fuzzy Support Software. Up to 8 inputs and 4 outputs OMRON CVM1-CLK12 (H-PCF CABLE) Installation Guide. CV500-HD SYSMAC BUS PC Unit Hard Disk Drive For 200 VAC CV500-HDD02.Unit type: CJ1 Special I/O Units OMRON CVM1-CLK12 (H-PCF CABLE) Installation Guide.
Product name: Analog Output Unit.
I/O points: 4 outputs;
Signal range selection:
Set separately for each output.
Signal range, Resolution: 1 to 5 V,
0 to 5 V, 0 to 10 V, -10 to 10 V,
4 to 20 mA; 1/4,00.
Conversion period: 1 ms/point.
Accuracy at ambient temperature of 25°C:
Voltage: ±0 OMRON CVM1-CLK12 (H-PCF CABLE) Installation Guide. 3% of F.S. Current: ±0.5% of F.S.
External connection: Removable terminal block.
External power supply: 24 VDC +10% -155%, 200mA max CVM1-CLK12 (H-PCF CABLE) .
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.12A; 24V, 0.2*3.
Standards: UC1, N, L, CE.
Consistent Microsecond Throughput:
Models with Direct Conversion Join the Lineup.
Anallog Input Units for converting analog input,
signals into binary data CVM1-CLK12 (H-PCF CABLE) Manual.
Analog Output Units for converting binary ,
data into analog output signals.