Programmable Terminals GT1-AD08MX Manual OMRON GT1-AD08MX SETUP MANUAL

Category: relay output.
Points: 8 points (1a * 8).
Common line processing on the connector side: corresponding (+ public).
Rated voltage: DC24V.
To achieve the control cabinet of miniaturization / save time,
Relay terminal for 8 point output.
Small size of 136 * high 80 * 55mm. (vertical installation)
The total wiring of the connector cable is realized GT1-AD08MX Manual.
The common end can be easily connected with the independent contact and the short circuit piece GT1-AD08MX
The G70D-SOC08 and G70R-SOC08 are connected by a short circuit chip.
When the relay does not need the tool, the relay is convenient to replace the work.
With terminal cover to prevent electric shock.
Diode for internal coil surge absorption.
DIN guide rail installation, screw mounting common GT1-AD08MX Manual. Control terminal block: Terminal block with small slotted screws.
Type: Standard.
Capacity: 45 A, 100 to 240 VAC.
Heater burnout detection: No.
Communications: No.
High-precision Control with Easy Setup,
Precise heater burnout detection.
Set value and present value monitoring with indicators.
Phase control or optimum cycle control.
RS-485 communications to set manipulated variables and,
monitor load current GT1-AD08MX Manual.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,
and constant-current control.
Application with various loads: constant load resistance,
variable load resistance OMRON GT1-AD08MX SETUP MANUAL.
UL, and IEC/EN (TÜV) certified. Terminal (Wire connection): Push-In Plus Terminal OMRON GT1-AD08MX SETUP MANUAL.
Classification: Microloads.
Latching lever (Test switch): No.
Rated input voltage: DC, 24V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel OMRON GT1-AD08MX SETUP MANUAL.
Realized opening and closing ability with one pole 6 A slim shape.
Micro load products for one pole 50 mA ussing Au-plated GT1-AD08MX .
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed locatiion) GT1-AD08MX Manual.
Screw terminal is also stocked to meet the screw type needs.
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging.