OMRON XS2F-D421-J80-R

Actuator: Roller lever: R38.
Wiring specification: NC wiring.
Item: Anti-coolant; High-sensitivity.
Pretravel (PT): 10°.
Select the Best Two-circuit Switch for the,
Operating Environment and Application,
from a Wide Range of Models,
A wide selection of models is available, including General-purpose,
Environment-resistant, and Spatter prevention Switches OMRON .
Standard-feature gold-clad crossbar contacts provide high reliability XS2F-D421-J80-R
Applicable to either standard loads or microloads.
Switches with Lever Actuators provide 90° overtravel,
one-side operation, and four-direction head mounting.
Approved standards: EN/IEC, UL, cUL, and CCC OMRON .
Contact your OMRON representative for information on approved models . Time specification: Instantaneous type.
Current setting range: 20 to 65 A.
Operating voltage: 200/220/240 VAC.
Resetting method: Automatic (See note.).
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage OMRON .
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase .
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, and load conditions. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
before using the K2CM. Ratings: 1 A at 30 VDC.
LED indicator: With indicator.
Actuator: Sealed pin plunger.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick with Connector.
New ceenter roller lever models that enable ganged mounting OMRON XS2F-D421-J80-R.
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection.
Operation indicators available for easy monitoring,
((sttandard indicator is lit when Switch is not operating) OMRON XS2F-D421-J80-R.
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models.)
XS2F-D421-J80-R Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=XS2F-D421-J80-R&select=5