OMRON C200HW-ATT34

Actuator: Hinge roller lever.
Stable Operation at an Ambient.
Temperature of 400°C.
Incorporates a ceramic insulator, cobalt-alloy spring, and special,
alloy contact, thus ensuring high contact reliability at high.
ambient temperature.
Smoothly operates at an ambient temperature of 400°C. Contact type: Microload (125 VAC, 0 OMRON . 1 A; 30 VDC 0.1 A).
Operation: Momentary operation (Self-resetting) C200HW-ATT34
Output: DPDT.
Lighting: Incandescent lamp, 28 VDC.
Operation Unit color symbol: Enter the desired color symbol for the Pushbutton,
in @@. R (Red); Y (Yellow); G (Green); A (Blue); W (White).
Pushbutton Switch Series with OMRON .
Square 40-mm Body.
Combines miniature design with distinct but soft sense of operation .
Easy panel mounting from the front and simple lamp replacement.
without tools. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points OMRON .
Heater break, SSR fault detection function: single phase heater detection function .
Event entry point: 2.
Transfer output: -.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can perform flexible contact output.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller. Isolation: Phototriac coupler.
Zero cross function: Yes.
Indicator: Yes.
Rated output load: 30 A at 180 to 400 VAC.
Rated input voltage: 12 to 24 VDC.
Extremely Thin Relays Integrated with Heat Sinks.
Downsizing achieved through optimuum design of heat sink OMRON C200HW-ATT34.
Mounting possible via screws or via DIN track.
Close mounting possible for linking terminals.
(Except for G3PA-260B-VD and G3PA-450B-VD-2.)
Applicable with 3-phase loads.
Replaceable power element cartridges.
Comply witth VDE 0160 (finger protection),
with a dielectric strength of 4,000 V between input and load OMRON C200HW-ATT34.
Certified by UL, CSA, and VDE (reinforced insulation).
C200HW-ATT34 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=C200HW-ATT34&select=5