FR-F840-06830-2-60 MITSUBISHI FR-F840-06830-2-60

Type: MR-J_B series.
Rated output: 2.0KW.
Interface: standard.
Servo system according to the system structure can be divided into open loop servo system, closed loop servo system, semi closed loop system, compound control system.
The closed loop automatic control system with feedback is composed of a position detecting part, a deviation amplifying part, an executing part and a controlled object MITSUBISHI FR-F840-06830-2-60.
Servo system must have good controllability, high stability and high adaptability FR-F840-06830-2-60
Note that the control of the signal is good after the disappearance of the signal, can immediately stop the turn;
High stability is the torque with the increase of speed and uniform decline; adaptability is fast, sensitive, and ring state quality is good MITSUBISHI FR-F840-06830-2-60.
According to the types of servo drives are classified, there are three kinds of electric, hydraulic or electric hydraulic.
If the servo system is divided according to the function, then there is a measuring servo and power servo system;
Analog servo and power servo system; position servo and acceleration servo system MITSUBISHI FR-F840-06830-2-60.
The electric servo system can be divided into two categories: DC DC servo system and AC AC servo system based on the electrical signals .
AC AC servo system also has two kinds of asynchronous motor servo system and synchronous motor servo system. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 0.75kw.
SLD converter rated current: 2.3A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 0.75kw.
Interface: general purpose interface.
Voltage: single phase AC200V.
MITSUBISHI servo system in the MITSUBISHI servo amplifier is widely used,
It can not only be used in the high precision position control and speed control of the working machinery and general industrial machinery,
Can also be used in the field of speed control and tension control.
By installing a personal computer with a sservo setting software,, the parameters setting, trial run, state display, and gain adjustment are performed FR-F840-06830-2-60.
MITSUBISHI servo system MR-J2S column is developed on the basis of the servo MR-J2 series with a higher performance and more features of thhe MITSUBISHI servo system,
The control modes are position control, speed control and torque control, as well as the switching control mode among them FR-F840-06830-2-60.
FR-F840-06830-2-60 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FR-F840-06830-2-60&select=5