MITSUBISHI MR-J3-20BS1

Max input / output points: 14 points.
Supply voltage: 100 - 240VAC.
Input points: 8 points.
Output points: 6 points.
Output type: Transistor (source).
Power consumption (W): 6.5.
Weight (kg):0.22.
Size (WxHxD) mm:60x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types MITSUBISHI .
This type of PLC is mainly used in all of the digital input, digital output control point of the device MR-J3-20BS1
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor MITSUBISHI .
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O .
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication. Motor series: ultra low inertia, low power.
Rated output power: 0.75kw.
Rated speed: 3000r/min.
Whether to bring the brakes: with MITSUBISHI .
Shaft keyway: (open slot).
Protection level: IP55 does not include the shaft part and the connector .
Features: ultra low inertia is suitable for high frequency operation.
Application examples: the insertion device, the assembly machine. Control mode: 2 position control, PID control (with self tuning), PI control.
Control operation period: 500ms.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
2 pass temperature input and 2 channel transistor output,
1 modules can be 2 systems for temperature regulation.
Single module to support PID (with self tuning), 2 position control, PI control.
Can be detected by the current detector (CT) is out of line. Input type: DC input, positive common end.
Input points: 8 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/5mA.
Output form: transistor output, leakage type.
Output points: 8 points.
OFF leakage current: 0.25mA.
Output protection function.
Rated load voltage / current: DC24V/0.5A.
External connection: 4 wire.
Fast connector type.
Simple wiring through quick connector.
Can be installed along the 6 direction.
MITSUBIISHI PLC program simulationn debugging
The basic idea of program simulation debugging is,
In order to facilitate the form of simulation to generate the actual state of the scene,
Create the necessary environmental conditions for the operation of thee prrogram MITSUBISHI MR-J3-20BS1 MITSUBISHI MR-J3-20BS1.
Depending on the way the field signals are generated,
The simulation debugging has two forms of hardware simulation and software simulation.
MR-J3-20BS1 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J3-20BS1&select=5