MITSUBISHI MR-J4-100A4-RJ

Protective film for 12.1 inch screen.
Scrub (frame: white), 5.
Applicable model: GT15. Input voltage rating: AC100/120/230/240V
External connection mode: module power supply: Terminal 3 pin (M3 screw), communication line / module power supply unit.
Dedicated power supply for CC-LINK/LT system with built-in 2A power supply MITSUBISHI . Compact flash memory card.
Capacity: 4GB bytes. Motor series: medium inertia, medium power MR-J4-100A4-RJ
Rated output power: 1.2kw.
Rated speed: 1000r/min.
Whether to bring the brakes: with.
Shaft end: Standard (straight).
Protection level: IP65 (IP67).
Features: medium inertia from low speed to high speed three modes for selection, suitable for different applications MITSUBISHI .
Application examples: transmission machinery, robots, X-Y working platform .
High resolution encoder 131072p/rev (17 bit).
The encoder with high resolution ensures excellent performance and stability at low speed.
All motor dimensions are the same as before and all are compatible with the wiring. Enter 16 points: 24VDC.
Response time 1 MITSUBISHI . 5ms.
Waterproof type.
4 wire type.
Waterproof connector type.
MITSUBISHI PLC hardware implementation
Hardware implementation is mainly for the control cabinet and other hardware design and field construction .
Design control cabinet and the operating table and other parts of the electrical wiring diagram and wiring diagram.
Electrical interconnection diagram of each part of the design system.
According to the construction drawings of the site wiring, and carry out a detailed inspection.
Because the program design and hardware implementation can be carried out at the same time,
So the design cycle of the MITSUBISHI PLC control system can be greatly reduced.
MITSUBISHI PLC online debugging.
On-line debugging is the process that will through the simulation debugging to furtherr carry on the on-line unificaation to adjust MITSUBISHI MR-J4-100A4-RJ.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on stepp bby step MITSUBISHI MR-J4-100A4-RJ.
If you do not meet the requirements, the hardware and procedures for adjustment.
Usually only need to modify the part of the program can be.
MR-J4-100A4-RJ Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J4-100A4-RJ&select=5