MITSUBISHI GT01-C100R2-6P GT01-C100R2-6P

Protective film for 5.7 inch screen.
Transparent (frame: white), 5.
Applicable model: GT15. Three-phase 3 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information MITSUBISHI GT01-C100R2-6P.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information GT01-C100R2-6P
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm MITSUBISHI GT01-C100R2-6P.
Only in the ON state can be used to measure the output of the output device .
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products MITSUBISHI GT01-C100R2-6P.
For example, a module can be used to measure other loads from the control panel trunk.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.3C-2V/5C-2V coaxial cable.
Single bus.
Remote I/O network (remote control station).
How to choose MITSUBISHI PLC.
MITSUBISHI PLC options include the choice of MITSUBISHI PLC models, capacity, I/O module, power, etc..
MITSUBISHI PLC distribution I/O points and design MITSUBISHI PLC peripheral hardware circuit
Draw the I/O point of the PLC and the input / output device connection diagram or the corresponding table,
This part also can be carried out in second steps.
Design PLC peripheral hardware circuit.
Draw the electrical wiring diagram of the other parts of the system,
Including the main circuit and the control circuit does not enter the PLC, etc..
The electrical schematic diagram of the system composed of I/O PLC connection diagram and PLC peripheral electrical circuit diagram.
So far the system''s hardware electrical circuit has been determined. Input and output points: 64 points.
Input points: 32 points.
Input specifications: drain / source.
Output points: 32 points.
Output form: transistor output (source).
Power consumption: 11W.
Weight: 0.3KG.
Outline dimension: 59.7x90x87mm.
Hard and compact type third generation micro programmable controller.
Connector type input and output type provincial connection.
Greatly strengthened the industry''s highest level of high-speed processing and positioning and other built-in features.
High cost of the province space models.
FX3UC in the province of space, the province also greatly strengthened the connection of high-speed processing and positioning and other built-in features.
The host is built in DC24V power supply, the connector input and output form of the transistorr output .
In addittion, according to the product mix can also achieve network communications, analog control, data collection and other functions GT01-C100R2-6P.
Third generation high function micro programmable controller.
Connector type can save space, province wiiring GT01-C100R2-6P.
Built in high speed processing and positioning.
Ultra small size, control points to 256 points.
Construction of CC-Link remote I/O 384 points.
GT01-C100R2-6P Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=GT01-C100R2-6P&select=5