MITSUBISHI MR-J2-20A1 MR-J2-20A1

Cable length: 5m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-H products have a long flex life. Motor series: low inertia, medium and small capacity.
Using a serial absolute / incremental encoder.
Rated output power: 3.5kw.
Rated speed: 2000rpm MITSUBISHI MR-J2-20A1.
With the brake: without.
Shaft end: straight shaft.
Comparison of single phase induction motor and servo motor MR-J2-20A1
The working principle of the AC servo motor is similar to that of the single phase induction motor,
But the rotor resistance of the former is much larger than that of the latter,
So the servo motor is compared with the single machine asynchronous motor,
There are three notable features:
1, large starting torque MITSUBISHI MR-J2-20A1.
2, a wide range of operation.
3, no rotation phenomenon.
AC servo motor running smoothly, low noise.
But the control characteristic is non-linear, and because the rotor resistance is big, the loss is big, the efficiency is low,
Therefore, compared with the same capacity DC servo motor, the volume is large and the weight is heavy,
So it is only suitable for 0 MITSUBISHI MR-J2-20A1. 5-100W small power control system. Analog channel: 12 channels.
Input / output (resolution): 0 ~ 4000.
Conversion speed: 100ms/12 channel.
Analog module installation.
Power supply: AC170V ~ 264V.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a haard wired way, and the timeliness is strong MR-J2-20A1.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness MR-J2-20A1.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
MR-J2-20A1 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J2-20A1&select=5