MITSUBISHI MR-J3-100BS Price MR-J3-100BS

The length of the line: 10M.
IP level: IP65.
Cable lead out direction: motor shaft different side.
Bending life: high bending life.
The cable is not shielded.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Motor series: low inertia, medium capacity.
Rated output power: 37 MR-J3-100BS Price. 0kw.
Rated speed: 1000rpm.
With the brake: without.
Voltage: 400V level.
Shaft end: straight shaft MR-J3-100BS
The rotor of the servo motor is a permanent magnet, which is controlled by the U/V/W,
The rotor rotates under the action of the magnetic field, and the encoder feedback signal of the motor is given to the driver,
According to the feedback value and the target value, the driver adjusts the rotation angle of the rotor MR-J3-100BS Price.
Accuracy of the servo motor depends on the accuracy of the encoder (number of lines). QCPU (Q mode) bus connection.
2 joint.
Applicable models: A985 (-V) /975/970/960GOT. DC input points: 8 points.
Input voltage and current: 7mA, DC24V.
Input response time: 10ms.
8 point /1 a public side MR-J3-100BS Price.
Positive pole sharing.
Output points: 8 points.
Output voltage and current: DC24V .
Output response time: 2ms.
8 point /1 a public side.
Output form: transistor output, leakage type.
40 point terminal station.
MITSUBISHI PLC protection and chain procedures.
Protection and chain is an indispensable part of the program, must be carefully considered.
It can avoid the control logic confusion caused by illegal operations.
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc..
MITSUBIISHI PLC program simulationn debugging
The basic idea of program simulation debugging is,
In order to facilitate the form of simulation to generate the actual state of the scene,
Create the necessary environmental conditions for the operation of thee prrogram MITSUBISHI MR-J3-100BS MITSUBISHI MR-J3-100BS.
Depending on the way the field signals are generated,
The simulation debugging has two forms of hardware simulation and software simulation.
MR-J3-100BS Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J3-100BS&select=5