MITSUBISHI MR-J2-350B

Superior high efficiency IPM motor.
Output power: 5.5kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MITSUBISHI . Power: 5.5kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current MR-J2-350B
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity.
At the same time the installation options in the use of 75kW and above motor MITSUBISHI . (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor .
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) 230.4kbps Max., RS-232 2 channel.
When using the serial communication module, it is only necessary to select from the communication protocol library of engineering software,
Can carry out data communication support MODBUS general agreement MITSUBISHI .
2 channels are supported 230.4kbps, communication can fully play the performance of the matching equipment. Protective film for 8.4 inch screen.
Transparent (frame: white), 5.
Applicable model: GT16. "MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 2.0kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC-Link
Simply setting the point table.
AC servo can be used as the driving source of the field network.
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and display can also be transmitted through the CC-Link.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed. "4 axes, open collector output type.
2 axis /4 axis /3 axis linear interpolation.
2 axis interpolation.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
Maximum pulse output: 200Kpps.
40 pin connector.
Positioning module.
Open collector output.
Differential driver output.
Baased on the use of open coollector outputs and differential drive output type 2 types MITSUBISHI MR-J2-350B.
Differential driver output type positioning module can transmit high speed instruction pulse (up to 4Mpps) to the servo amplifier reliably,
Transmission distance off up to 10 meters, to achieve high speed and high precision control MITSUBISHI MR-J2-350B.
(the command pulse of the open collector positioning module is highest 200kpps.)
MR-J2-350B Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J2-350B&select=5