MITSUBISHI AJ65BTB2-16DR AJ65BTB2-16DR

Servo motor series: low inertia, medium and large capacity.
Rated output: 6.0kw.
Rated speed; 3000r/min.
Electromagnetic brake: incidental.
Power supply: 200V.
Most suitable for medium and large capacity, low inertia type products in high frequency operation or acceleration and deceleration operation MITSUBISHI AJ65BTB2-16DR.
Improve the environmental performance of HG-SR, HG-JR series of products using IP67.
High speed & high torque AJ65BTB2-16DR Shorten the positioning time, achieve high-speed equipment.
100 scene, there are 100 different drive control.
In order to meet the needs of the diverse and detailed field,
MR-J4 product line configuration, providing a wealth of servo amplifier and servo motor products MITSUBISHI AJ65BTB2-16DR.
Can meet the different needs of different customers . MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 1.5kw.
SLD converter rated current: 3.8A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed MITSUBISHI AJ65BTB2-16DR.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption .
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. Input points: 32 points
Input mode: DC24V (drain / source).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points. JEMANET (OPCN-1) interface unit master station.
The response time of PLC is the interval between the time of the change of the external output signal of the PLC and the time of the change of the external output signal which is controlled by it,
Lag time, this is the time constant of the input circuit,
The time constant of the output circuit, the arrangement of the user statement and the use of the instruction,
The cycle scan mode of PLC and the way of PLC to refresh the I/O and so on. .
This phenomenonn is called the I/O delay time effect AJ65BTB2-16DR.
Input status and input information input from the input interface,
CPU will be stored in the working data memory or in the input image register.
And then combine the data and the program with CCPUU AJ65BTB2-16DR.
The result is stored in the output image register or the working data memory,
And then output to the output interface, control the external drive.
AJ65BTB2-16DR Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=AJ65BTB2-16DR&select=5