MITSUBISHI HC-KFE43 HC-KFE43

Power: 11kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor MITSUBISHI HC-KFE43.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table HC-KFE43
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate MITSUBISHI HC-KFE43.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor .
The installation of thermal relay, to avoid overheating and burn the braking resistor. Power: 15kw.
Voltage: 200V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor MITSUBISHI HC-KFE43.
Can also be connected without built-in brake transistor inverter .
Three types of discharge resistors are available.
Please select according to the required braking torque. MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 55.0kw.
SSCNET interface.
Voltage: 3 phase AC400V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
Thiss simple connnection method reduces the routing time and helps to prevent noise HC-KFE43.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the seervvo amplifier, which can form the absolute value system HC-KFE43.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.
HC-KFE43 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=HC-KFE43&select=5