MITSUBISHI HF-KP23BK HF-KP23BK

MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 2.2kw.
SLD converter rated current: 5.2A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed MITSUBISHI HF-KP23BK.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption HF-KP23BK
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency MITSUBISHI HF-KP23BK.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control . Cable length: 3m.
Connection between serial communication unit and GOT. Connection between a computer link unit and a GOT.
For the connection between AJ65BT-R2N and GOT (only GT09-C30R2-9P).
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 MITSUBISHI HF-KP23BK. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.6kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: three phase AC400V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and moonitoring and other operations HF-KP23BK.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

Thhe servo amplifier can be used for speed control operation HF-KP23BK.
When the two stations are occupied, the speed can be set directly by the remote register.
HF-KP23BK Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=HF-KP23BK&select=5