OMRON 82491-0195 MS46EPLR-30-610-Q1

Ratings: Standard load; 0.1 A at 125 VAC, 0.1 A at 30 VDC.
Cable: VCTF cable *2.
Actuator: Pin plunger.
Cable length : 3 m.
Compact Limit Switch That''s Also.
Thin and Highly Sealed.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models OMRON . )
Sealing characteristics that meet IEC IP67 degree of protection.
Triple-sealed construction:
Plunger section sealed via nitrile rubber packing seal and,
diaphragm; switch section sealed via nitrile rubber cap;
cable entrance sealed via encapsulating material 82491-0195 MS46EPLR-30-610-Q1
Cable lengths of 3 and 5 m available on standard models OMRON .
Models also available with UL and CSA-certified cables.
Multiple mounting possible with Switches with Plungers .
Models with red LED indicators added to series for easy,
confirmation of operation.
(Set by default to light for non-operation.)
VCTF oil-resistant cables with CE marking.
(Applicable only to standard models.)Contact type: Standard load (250 VAC, 3 A; 30 VDC, 4 A) OMRON .
Operation: Alternate operation (Self-holding).
Case color: Light gray.
Output: SPDT .
Lighting: LED; 24 VDC.
Pushbutton color symbol: R.O.G.W.
Large Square-bodied Lighted.
Pushbutton Switches.
Excellent operating sensitivity.
Excellent illumination with even surface brightness.
Three-color models (green, orange, red; chameleon lighting).
included in lineup. Type: 1A contact type.
Shape: round.
Terminal shape: terminal for printed board.
Action: instantaneous.
Display mode: LED display.
Operation Department color: red.
Large capacity compact type push button switch.
Can also be used as a power switch with a large capacity cut.
Can be switched from micro load (minimum applicable load 1mA DC5V) to large capacity load. Servo trunk unit.
Product Name: servo relay unit.
Application unit: CS1W/CJ1W-NC__3.
Specification: with communication function support.
Axis number: biaxial.
The connector and terminal of the relay unit are integrated into a whole,
Save the wiring servo drive and position control unit.
Seervo driver and control signal of positiion control unit,
Simple wiring on terminal stage OMRON 82491-0195 MS46EPLR-30-610-Q1.
The connector without soldering, with only a screwdriver can wiring.
Dedicated connection cable between units.
DIN guide rail installation, the rapid installaatiion, screw installation of two methods OMRON 82491-0195 MS46EPLR-30-610-Q1.
M3.0 thread terminals attached with a special plate signal.
The terminal can be confirmed by the signal name.

82491-0195 MS46EPLR-30-610-Q1 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=82491-0195 MS46EPLR-30-610-Q1&select=5