Brand sort
OMRON ZN9-JH04
next one: 
Last one: OMRON ZN9-JH04
Size: DIN 1/4, 96 x 96 x 78mm.
Power supply voltage: AC100 ~ 240V.
Alarm points: 3 points.
Control output: relay.
Input: Platinum resistance.
New generation intelligent general temperature controller.
The thickness is only 78 mm.
Various temperature inputs: thermocouple, platinum resistance, non contact temperature sensor signal input OMRON .
Automatic adjustment and self adjustment.
Automatic adjustment can be performed even when the self adjustment is being performed ZN9-JH04
Can use heating or heating / cooling control.
Event entry allows multiple SP options and run / stop functions. No. of notches: 2 notches.
Output: SPDT.
Reset method: Manual OMRON .
Lighting method: LED.
Separate Construction with Cylindrical .
16-dia. Body.
Same separate construction as the A16-series Pushbuttons with,
Miniature Design of 28.5 mm.
The same contacts can be used for both standard loads and,
microloads.
Oil-resistant IP65 models,
Conforms to EN60947-5-1. Thermocouple type: K (CA).
Heat resistance: heat resistant.
External: silicon outer foreskin OMRON .
Compensating wire length: 2 m.
A variety of high precision temperature sensor series .
On the basis of the previous M3 screw,
An additional rod like terminal corresponding to the reduced wiring working hours.
A temperature sensor is used as a thermal sensor for a thermostat.
According to the temperature, place, the surrounding environment to be measured.
Products with various shapes, shapes, lengths and terminals.
Size: 48 * 48mm, terminal type.
Type: control output 1 point type (power AC/DC24V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase heater detection function.
Event entry point: 2.
Transfer output: -.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, tto see the state off the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV OMRON ZN9-JH04.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm fflexible contact output OMRON ZN9-JH04.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.
ZN9-JH04 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=ZN9-JH04&select=5
Power supply voltage: AC100 ~ 240V.
Alarm points: 3 points.
Control output: relay.
Input: Platinum resistance.
New generation intelligent general temperature controller.
The thickness is only 78 mm.
Various temperature inputs: thermocouple, platinum resistance, non contact temperature sensor signal input OMRON .
Automatic adjustment and self adjustment.
Automatic adjustment can be performed even when the self adjustment is being performed ZN9-JH04
Can use heating or heating / cooling control.
Event entry allows multiple SP options and run / stop functions. No. of notches: 2 notches.
Output: SPDT.
Reset method: Manual OMRON .
Lighting method: LED.
Separate Construction with Cylindrical .
16-dia. Body.
Same separate construction as the A16-series Pushbuttons with,
Miniature Design of 28.5 mm.
The same contacts can be used for both standard loads and,
microloads.
Oil-resistant IP65 models,
Conforms to EN60947-5-1. Thermocouple type: K (CA).
Heat resistance: heat resistant.
External: silicon outer foreskin OMRON .
Compensating wire length: 2 m.
A variety of high precision temperature sensor series .
On the basis of the previous M3 screw,
An additional rod like terminal corresponding to the reduced wiring working hours.
A temperature sensor is used as a thermal sensor for a thermostat.
According to the temperature, place, the surrounding environment to be measured.
Products with various shapes, shapes, lengths and terminals.
Size: 48 * 48mm, terminal type.
Type: control output 1 point type (power AC/DC24V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase heater detection function.
Event entry point: 2.
Transfer output: -.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, tto see the state off the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV OMRON ZN9-JH04.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm fflexible contact output OMRON ZN9-JH04.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.
ZN9-JH04 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=ZN9-JH04&select=5
...more relevant model market price >>>>
Related products