Q173J2B2CBL1M MITSUBISHI Q173J2B2CBL1M

Input voltage range: AC100-120V/AC200-240V.
Output voltage: DC5V.
Output current: 8A.
For Q4ARCPU.
The control module monitors the power supply, the error
CPU state,
And its own error state.
It sends out
Error signal a6raf and open the corresponding
Relay output.
I/O points is an important indicator of PLC MITSUBISHI Q173J2B2CBL1M.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest Q173J2B2CBL1M
The input and output points and types of PLC should be determined according to the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point MITSUBISHI Q173J2B2CBL1M.
Taking into account the future adjustment and expansion,
In general should be estimated on the total number of points plus the amount of spare 20%~30% .
The following describes the centralized control system I/O points of the estimate. Protocol: SLMP, TCP/IP, UDP, SNTP.
Communication mode: full duplex / half duplex.
At the same time can open a few: 4 connection MITSUBISHI Q173J2B2CBL1M.
Weight: 0.3kg.
Can be low cost will be connected to the FX3 series Ethernet .
Support data monitoring, can monitor the basic unit through the computer browser,
Remote maintenance can be carried out by Works2 GX in a place far from the scene.
Connect FX3SA, FX3S, FX3GA, FX3G, FX3U host, you need to convert the adapter or function expansion board. MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 22.0kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
Thiss simple connectioon method reduces the routing time and helps to prevent noise Q173J2B2CBL1M.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the seervvo amplifier, which can form the absolute value system Q173J2B2CBL1M.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.
Q173J2B2CBL1M Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=Q173J2B2CBL1M&select=5