Q312B MITSUBISHI Q312B

Power: 220kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. 5 in each package.
Application: to protect the surface of the display, to prevent the operation of oil or other material pollution MITSUBISHI Q312B.
The contaminated part of the adhesive film can be replaced Q312B
Specifications: 120*45mm.
Application Series: F930GOT. DC input points: 16 points.
Input voltage and current: 3/7mA, DC12/24V.
Response time: 10ms.
16 point /1 a public side.
Positive pole sharing.
Output points: 12 points MITSUBISHI Q312B.
Output voltage and current: DC24V/AC240V, 2A/1 point, 5A/1 common end .
Response time: 12ms.
8 point /1 a public end, 3 point /1 a common end, independent contact.
Output form: relay output.
36 point terminal station.
Number of stations: 4 stops.
Compact remote I/O unit.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program MITSUBISHI Q312B.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system .
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of deebugging, debugging method can be used to segment, and the monitoring function of programmer Q312B. Superior high efficiency IPM motor.
Output power: 18kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the pooweer frequency power Q312B.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time.
Q312B Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=Q312B&select=5