Ratings: Standard load; 0.1 A at 125 VAC, 0.1 A at 30 VDC.
Cable: VCTF cable *2.
Actuator: Center roller lever.
Cable length : 3 m.
Compact Limit Switch That''s Also.
Thin and Highly Sealed.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models 3G3IV-PUZBAB 120A 0.09MH. )
Sealing characteristics that meet IEC IP67 degree of protection.
Triple-sealed construction:
Plunger section sealed via nitrile rubber packing seal and,
diaphragm; switch section sealed via nitrile rubber cap;
cable entrance sealed via encapsulating material
3G3IV-PUZBAB 120A 0.09MH
Cable lengths of 3 and 5 m available on standard models 3G3IV-PUZBAB 120A 0.09MH.
Models also available with UL and CSA-certified cables.
Multiple mounting possible with Switches with Plungers .
Models with red LED indicators added to series for easy,
confirmation of operation.
(Set by default to light for non-operation.)
VCTF oil-resistant cables with CE marking.
(Applicable only to standard models.)Logical AND Function Adds Flexibility to I/O Expansion 3G3IV-PUZBAB 120A 0.09MH.
Facilitates partial or complete control system setup.
Solid-state outputs (excluding Expansion Units) .
Detailed LED indications enable easy diagnosis.
TÜV SÜD certification for compliance,
with IEC/EN61508 (SIL3), EN ISO13849-1 (PLe/Safety Category 4).
Approved by UL and CSA.
New unit joins the Series with the following two additional features:
-OFF-delay time of up to 150 seconds can be set.
-Two logical AND connection inputs. Type: Multi-pole, Square Connector.
Terminal Block: Terminal block with M3.5 screws.
Connector: Multi-pole, Square Connector Plugs *2.
No. of poles: 50.
Simplifies Connector and terminal,
block replacement, and requires less,
in-panel wiring.
Mount to DIN Track or via screws.
MIL Flat Cable Connectors and Multi-pole, Square,
Connectors are standard.
Terminal blocks available with either M3 or M3.5 screws.
Connecting Cables for Programmable Controllers,
available (sold separately). High-Speed and High-Precision.
G5 Series MECHATROLINK-II.
Communications with the Controller.
Data transfer using MEECHATROLINK-II .
Communications:
All control data that can be interfaced between the Servo Driver,
and the Controller is transmitted using data communications OMRON 3G3IV-PUZBAB 120A 0.09MH.
This enables maximizing the Servomotor performance without,
restricting the transmisssiion performance of the control signals OMRON 3G3IV-PUZBAB 120A 0.09MH.
Having a communications module built into the Servo Driver,
significantly saves space in the control panel.
3G3IV-PUZBAB 120A 0.09MH Operation manual/Instructions/Model selection sample download link:
/searchDownload.html?Search=3G3IV-PUZBAB 120A 0.09MH&select=5