Sale GT16-90XLTT MITSUBISHI GT16-90XLTT

Through a series of holes available to install FR-A800 using the original FR-A500 series.Type: HA-FE series.
Rated output: 0.6KW.
Rated speed: 3000r/min.
Electromagnetic brake: there.
Control complex, easy to achieve intelligent,
The electronic commutation method is flexible and can be changed by square wave or sine wave GT16-90XLTT.
Motor maintenance free, high efficiency, low operating temperature,
Electromagnetic radiation is very small, long life, can be used in a variety of environments GT16-90XLTT
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
Synchronous machines are commonly used in motion control,
Its power range, you can do a lot of power GT16-90XLTT.
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction .
So it is suitable for the application of low speed and stable operation.
The rotor of the servo motor is permanent magnet,
Drive controlled U/V/W three phase electric electromagnetic field,
The rotor rotates under the action of the magnetic field,
At the same time the motor comes with the encoder feedback signal to the drive,
According to the feedback value and the target value, the driver is compared,
Adjust the rotor rotation angle GT16-90XLTT.
The accuracy of the servo motor is determined by the accuracy of the encoder. Specification: allowed regeneration power: 500W, resistance value: 13 ohm.
Uses: MR-JE-200B, MR-JE-300B, MR-JE-200A, MR-JE-300A with. Needle number: 40.
Specification: loose wire connector, 5 sets (0.3mm 2). Input type: DC input, positive common end.
Input points: 16 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/6mA.
External connection: 3 wire.
Spring clamping terminal platform push type input module.
Input module with diagnostic function
The use of push type, do not need screw fastening, so can reduce the wiring hours.
Can be used for each 1 points to enter the wiring of the broken wire detection.
Wiring abnormality of external power supply can be confirmed.
Using 2 pieces of structure of the terminal units, maintenance can be maintained in the same line under the condition of the replacement module. Input points: 16 points.
Rated input voltage and frequency: DC24V.
Rated input current: 6.0mA.
Response time: 5 S ~ 70ms.
Common way: 8 point / public end (negative public end).
Interrupt function: have.
External wiring connection mode: 18 point screw terminal.
The input module is the most used module in the control system.
According to the input voltage, the input points of different, choose the most suitable user needs of the module.
1 modules are equipped with a variety of functions.
Can be through a single input module to 1 points for the unit to set the high speed response, interrupt input function.
In aaddition, the public end off the module can be freely selected as the common end of the positive pole and the negative pole MITSUBISHI GT16-90XLTT.
It is not necessary to use different modules according to the input specifications and functions, and reduce the number of mmoddules,
Therefore slot occupied quantity can be reduced by 20% than in the past, the deployment cost can be reduced by 60% compared with the previous MITSUBISHI GT16-90XLTT.
GT16-90XLTT Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=GT16-90XLTT&select=5