E2E2-X3D2 5M OMRON E2E2-X3D2 5M

Sensing method: Diffuse-reflective Sensors.
Appearance: Vertical.
Connection method: Pre-wired.
Sensing distance: 200 mm.
Functions: --.
Model: PNP output.
Ordering Information.
Built-in Amplifier Photoelectric Sensors. Terminal (wire connection): Screw terminal.
Applicable output load: AC load OMRON E2E2-X3D2 5M.
Zero cross function: Yes.
Rated input voltage: DC 12V.
Global standard size,
low profile slim I/O relay with width 6 E2E2-X3D2 5M2 mm,
slim I/O solid state relay.
Realized about 25% lower profile than conventional,
products, contributing to further miniaturization of the,
control panel.
Push-In Plus terminal blocks are used to save wiring work,
in comparison with conventional screw terminals OMRON E2E2-X3D2 5M.
(Wiring time is reduced by 60%* in comparison with,
traditional screw terminals . ).
No screw loosening means maintenance-free application,
realizing high reliability.
Hand-free structure that holds an inserted flat-blade,
screwdriver to achieve easier wiring work for stranded wires.
Screw terminal is also stocked to meet the screw type needs OMRON E2E2-X3D2 5M.
Mounted relay or solid-state relay has a plug-in terminal .
that is difficult to bend at the time of exchange. Size: 1/16 DIN 48 × 48 × 78 (W × H × D).
Power supply voltage: 100 to 240 VAC.
Input type: Analog (current/voltage).
Alarm output: 2.
option units Mounting: Yes.
Control output: Current output.
Previous mode: None.
This Best-selling General-purpose,
48×48-mm Temperature Controller,
Is Now Even Better.
Controllers now available with analog inputs.
Faster sampling at 250 ms.
Transfer output provided for easy output to recorders.
Models available with a loop break alarm (LBA) and,
heater short alarm (HS alarm).
Easy setting with 11-segment displays.
Setting protection indicator informs operator when,
protection is enabled.
Manual output provided.
New protocol called Modbus is installed in the models,
with communications.
USB-Serial conversion cable is available.
Note: Refer to Precautions on page 33. Category: external supply 100mA DC10V.
Input type: load sensor, mV input type.
Event input terminal 5 points (TIMING, S-TIM, HOLD, RESET, ZERO) is equipped with.
Relay contact: H; PASS1c, L: each 1c.
96 (W) * 48 (H * 95mm) depth.
Power supply voltage: AC100 ~ 240V.
To support the sensor innput, the pressurre, load, torque and weight were measured,
Is an ideal indicator for judging whether an automatic device and a screening device are qualified E2E2-X3D2 5M.
Action determine the color, can switch the green / Red 2 kinds of color display.
Equipppeed with the sub pressure gauge for monitoring the operation trend E2E2-X3D2 5M.
External event input can be applied to a variety of measurement and identification
E2E2-X3D2 5M Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=E2E2-X3D2 5M&select=5