Problem sort
The set problem of motion control module
Time: 4/16/2017 10:54:39 PM
Two axis e motion control module angle motion control module positioning axis ratio 5:1, after setting the calculated number of pulses per revolution 4194304, each transfer amount of 72, this is right, I set the shaft two gear ratio 7:1, calculated the number of pulses per revolution 114688, each transfer amount 1.40625, which seems to be much different for the first time in this module, please master pointing what the problem is...
Two axis e motion control module angle motion control module positioning axis ratio 5:1, after setting the calculated number of pulses per revolution 4194304, each transfer amount of 72, this is right, I set the shaft two gear ratio 7:1, calculated the number of pulses per revolution 114688, each transfer amount 1.40625, which seems to be much different for the first time in this module, please master pointing what the problem is...
Re： Time: 4/17/2017 1:32:00 AM
Please consult the "motion control and servo" section, the link is as follows: http://cn.mitsubishielectric.com/fa/zh/bbs/bbs_board_view.asp? BoardID=107 thank you.
Thank you for your support of MITSUBISHI automation products.
Welcome to call 400-- free technical hotline for further technical information.
Thank you for your support of MITSUBISHI automation products.
Welcome to call 400-- free technical hotline for further technical information.
next one: How to download a program NT5Z screen, how to download the program
Last one: Proface open application error
Related problems
Related products
MITSUBISHI
Safety CC-Link system remote I/O module
QS0J65BTB2-12DT
Input points: 8 points dual input, 16 point
MITSUBISHI
Simple motion control module
LD77MS2
Control axis: maximum 2 axes.
Operation cycle
MITSUBISHI
ID interface module
QD35ID1
Connect to read and write 1Ch.
ID system inte
MITSUBISHI
Ethernet module
A1SJ71QE71N3-T
10BASE-T.
Q mode.
MITSUBISHI PLC is the main
Related download