FX5U Ethernet communication problem

Time: 5/2/2017 9:44:02 AM

Hello I dmunication FX5U in FX5U the built-in Ethernet FX5U with built-in Ethernet and Q170MS, you can set the MC protocol in Q170MS, I think in the FX5U MC protocol to send instructions, but do not know what the FX5U Ethernet configuration in the Ethernet device (GM)? FX5U Ethernet configuration which can be used to support the communication protocol to send MC messages? Please advise! Thank you

FX5U can use communication protocol support function or socket communication MC protocol to send the message, if you want to support the function of communication protocol, Ethernet devices (GM) settings in Active connected devices, Fullpassive devices, UDP devices, means of communication protocol of the four Unpassive connected devices can choose to send the MC protocol function. General use Acti protocol message

After you have been set up, you will be connected to the Ethernet (FX5U Ethernet diagnosis) with the instruction SP.SOCOPEN. However, with the SP.ECPRTCL command to trigger the communication protocol to support the function of the corresponding protocol number when there is no response, there is no error, I do not know why? SD10692, SD10714 are normal. Protocol is added - communication protocol library, the model is -SLMP (Deviec read)

Communication protocol support function in the SLMP is not 3E frame, is the 4E frame.
Thank you for your support of MITSUBISHI automation products.
Welcome to call 400-- free technology hot a line for further technical information.

Hello 3E frame and 4E frame message in which manual can be found? Batch read
(Device Read) 0401H 0000H command to write a note of the 3E frame message format!
Thank you

You see the FX5 user manual (SLMP) in the message is the 3E frame, 4E frame of the message in the FX manual does not need to look at the manual Q.
Thank you for your support of MITSUBISHI automation products.
Welcome to call 400-- free technical hotline for further technical information.