A9GT-60PSC CC-Link connection unit MITSUBISHI A9GT-60PSC 

Cable length: 25m.
For long distance connections between QCPU and GOT (above 13.2M) (need A9GT-QCNB).
Long distance connection between two GOT.
Applicable models: GT16, GT15, GT11, GT27, GT25. Protective film for 5.7 inch screen.
Transparent, 5.
Applicable model: GT15. Cable length: 10m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT MITSUBISHI A9GT-60PSC.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT A9GT-60PSC
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. 1GB flash ROM.
Applicable models: GT16, GT15, GT11, HandyGOTConnecting cable for handheld RH GOT and PLC.
Cable length: 10 meters.
Application: RS-422 connection and RS-232C connection MITSUBISHI A9GT-60PSC. 256MB flash ROM.
Applicable models: GT16, GT15, GT11, HandyGOT. Function: the core function of the condensed display.
Picture size: 3.8 inches.
Resolution: 320 * 128 dot.
Display: TFT monochrome.
Panel color: black.
Power type: DC24V.
Communication interface: RS-232, RS-422/485, or only RS-422.
Small body equipped with ethernet!
Compared with the past, the upgrade of 320 x 128dot 4 x high resolution lcd MITSUBISHI A9GT-60PSC.
HD LCD screen.
Equipped with TFT monochrome 32 gray level of high resolution liquid crystal, compact body design and display the effect is clear.
1, SD memory card module with the interface.
Can be installed to buy the SD memory card module, save the alarm and log data MITSUBISHI CC-Link connection unit.
2, USB interface: device USB (Mini-B USB)
Can connect to the computer to transfer data.
3, RS-422/485 interface MITSUBISHI CC-Link connection unit.
Can be connected to a variety of FA machines, bar code reader.
4, Ethernet interface.
Up to 2 different manufacturers can be connected to the FA machine.
Backlight color variety, equipment status at a glance.
The use of direct 5 color backlight, according to the production of equipment, respectively, the use of backlight color / flicker MITSUBISHI CC-Link connection unit.
In addition, the control of the backlight can be carried out by connecting the programmable controller. (picture color switching, ON/OFF/ flashing backlight). QCPU (Q mode) bus connection.
1 joint.
Applicable model: A956WGOT. Protective film for 15 inch screen.
Transparent, 5.
Applicable model: GT16. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibbrated to the touch screen system A9GT-60PSC.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI A9GT-60PSC.