CA3-BLU12-01 Proface CA3-BLU12-01 Replace with backlight

For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 5 meters.Touch screen anti ultraviolet protective film (1 pieces).Used to connect the SIEMENS S5 PLC series to the host computer interface10.4 inches (TFT), replace the backlight (2 / set)COM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-machine interfaceUsed for surface protection of man-machine interface from oil and chemical pollution (5 / set) Proface CA3-BLU12-01 CA3-BLU12-01 GP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelFor RGB input USB cable to prevent disconnection (2 / set)Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interface Proface CA3-BLU12-01. 1-0 DVI standard (DVI-D 24 pin convex connector)Touch screen anti ultraviolet protective film (1 pieces).LT fasteners installed on the control panel (4 / set)7.4 inches or larger, for external reset input, NETWORK FLEX communication, audio output. AUX connector, L typeBackup battery for time and data backup (1).The MITSUBISHI Q series PLC is connected to GP, length: 5 m Proface CA3-BLU12-01. 7.5 inches, GP installed to the hard panel to provide dust and moisture proof function.The main controller is connected to the man-machine interface for MPI communicationCOM1 interface with the cable for direct connection to the CPU series PLC QCOM1 interface with the cable for direct connection to the CPU series PLC AUsed to install the GP3000H series to a commercially available support arm or panel Proface Replace with backlight Proface Replace with backlight. Standard interface cable for connecting GP and external devices (such as the main controller), with a universal filter.
Length of 10 meters. COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connectorA1/A2/B+ DIO Type connector (compression type) (5 / set)For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 1 meters Proface Replace with backlight CA3-BLU12-01. 3.4 Inch Touch Screen anti UV protective film (1 pieces).Suitable for GLC2300 seriesOne end is a loose wire, which is used to carry out RS-485 connection between the host and LT Proface CA3-BLU12-01. 10.4 inches (TFT), for the protection of the man-machine interface from oil and chemical pollution (5 / set).