CA4-ADPONL-01 Serial communication terminal adapter Proface CA4-ADPONL-01

1GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.Durable cable for connecting GP3000H adapter and GP3000H.Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interface Proface CA4-ADPONL-01. Extended cable for connecting USB (Type-A) (LT) interface.GP3000H replacement label (5 sheets / set)LT seal on the control panel CA4-ADPONL-0115 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connector (joint Cx 1, connector Dx1). Note: joints A and B are different, the joints C and D different.128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface CA4-ADPONL-01. Input / output hybrid I/O modules, including 32 point NPN/PNP input and 32 point NPN transistor outputTouch panel operation for RGB input modules (Master - from: Mini-B)COM1 interface with the cable for direct connection to the CPU series PLC ATo prevent the connection of disconnected USB cable fastening clips (Type-A USB, 1 interface, 5 / set)Interface module for the simultaneous use of A/QnA/FX series external controller3 Proface CA4-ADPONL-01. 5 inch screen protective cover (1 pieces)Used to output the image signal from the host computer to GP15 inches, replaced by a host of backlight (1).GP3000H portable slingThe main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module Proface Serial communication terminal adapter. For 3.8 inch models, connect the connector to the DIO interface Proface Serial communication terminal adapter. For connecting external I/O devices. (5 / set)COM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-machine interfaceUsed to prevent disconnection of the connection (1 interface, 5 / set).Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine Proface Serial communicationn terminal adapter CA4-ADPONL-01. For multi connection communication, length: 5 meters.Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communicationCOM1 interface with the cable (RS-232C), used to connecct directly to the CPU series PLC FX (not the same time using the programming controller)7 Proface CA4-ADPONL-01. 4 inches or larger, FLEX NETWORK GLC2300 connector (5 groups)