FX3S-CNV-ADP Adapter for special adapter connections MITSUBISHI FX3S-CNV-ADP

Master station module for CC-Link/LT.
I/O control can be used in the province of CC-LINK/LT.
Is to make PLC CC-LINK/LT as the main station of the FX system module.
The master station module and the remote I/O module can be connected by a special connector, and achieve the purpose of the distribution of the province MITSUBISHI FX3S-CNV-ADP.
Up to 64 remote I/O station modules can be connected.
Remote I/O module is assigned a common X, Y soft components,
By using the same procedure as the common input and output FX3S-CNV-ADP
Even if the use of 2 points, 4 points of the remote I/O module, the number of soft components can be continuously assigned,
So it can be efficiently allocated I/O. Control mode: 2 position control, PID control (with self tuning), PI control MITSUBISHI FX3S-CNV-ADP.
Control operation period: 500ms.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
2 pass temperature input and 2 channel transistor output,
1 modules can be 2 systems for temperature regulation.
Single module to support PID (with self tuning), 2 position control, PI control.
Can be detected by the current detector (CT) is out of line MITSUBISHI FX3S-CNV-ADP. Application: input power line for extended input module.
Length: 1.0m.
Auxiliary parts for FX3GC and FX3UC. Analog output expansion board (1 channel).
Can be installed in FX1N, PLC FX1S, providing 1 channel analog input of the board.
Because it is embedded in the PLC installation, so do not need to install space MITSUBISHI Adapter for special adapter connections.
Can easily control the speed of the inverter. Total points: 14 points MITSUBISHI Adapter for special adapter connections.
Input points: 8 points.
Output points: 6 points.
Voltage: AC220V.
Output type: relay.
Outline dimension: 60*75*90.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 MITSUBISHI Adapter for special adapter connections.
FX1S provides up to 30 I/O points, and can be transmitted through serial ccommunication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX3S-CNV-ADP. Analog input points: 4 channels
Voltage input range: DC0~10V.
Current input range: DC-20~20mA.
High precission analog input module with resolution of 11 bit binary + sign 1 bit, 10 bit binary + symbol 1 bit MITSUBISHI FX3S-CNV-ADP.
Can be 4 channel voltage input, or current input.