GPM-AXCN01 Proface GPM-AXCN01

Standard cable for connecting GP3000H adapter and GP3000H.
Length: 3 meters. Clock battery, save system date and time when power is off.USB cable to prevent disconnection of the fastening clip (5 / set)B/B+/C FLEX NETWORK Type connector (5)Touch screen anti ultraviolet protective film (1 pieces).For 5 Proface GPM-AXCN01. 7 inch models, for fixing the hooks of the three EX modules.The man-machine interface directly connected MITSUBISHI electric PLC FX series CPU programming port GPM-AXCN01For connecting GP operation data with D-Sub RS-232C and power /DIO terminals.Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interface.Used to convert RGB to DVI-ASuitable for GLC2300 seriesCOM1 interface with the cable for direct connection to the CPU series PLC QA1/A2/B+ DIO Type connector (welding type) (5 / set)Suitable for A/B+ Type modelsCOM2 adapter for converting the COM2 interface to the RS-422 terminal blockThe nut for mounting the display module (10 / set) Proface GPM-AXCN01. Transmission screen data of the USB cable, PC (Type-A USB) to the man-machine interface USB (Mini-B).5.7 inches, GP installed to the hard panel to provide dust and moisture proof function Proface GPM-AXCN01. When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function. (1)Stop pin, prevent cable connection loose USB cable fastening clip (Type-A*1 USB, Mini-B, each 1 interface), used to adjust the thickness of the mounting panel 2mm gasket (1 pieces) Proface Screw fixing terminal block. For connecting GP operation data with RS-422 and power /DIO terminals Proface Screw fixing terminal block. 7.5 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).A veneer, for the GP4000 series back loading models of full flush (white, 1)One end is a loose wire, which is used to carry out RS-232C connection between the host and LT Proface Screw fixing terminal block. When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function. (1)Converting 4 analog signals into digital signalsCOM1 pin adapter, which is used to connect the communication components that are dedicated to the COM2 interface to the COM1 interface of the man-machine interface GPM-AXCN01. 10.4 inch TFT models applicable parts, for the 10 Proface GPM-AXCN01. 4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.