HA-LFS8014B MITSUBISHI HA-LFS8014B

Motor series: low inertia, medium power.
Rated output power: 45.0kw.
Rated speed: 1500r/min.
Whether to take the brake: No.
Shaft end: Standard (straight).
Voltage: 400V type.
Protection level: IP65 (IP67).
Features: low inertia from low speed to high speed, three modes can be selected, suitable for different application range MITSUBISHI HA-LFS8014B. As a standard port, 30KW or greater power is suitable for flange (type) installation and support foot mounting HA-LFS8014B
Application example: injection molding machine, semiconductor manufacturing equipment, large conveyor machinery.
High resolution encoder 131072p/rev (17 bit).
The encoder with high resolution ensures excellent performance and stability at low speed.
All motor dimensions are the same as before and all are compatible with the wiring MITSUBISHI HA-LFS8014B. Servo motor series: medium inertia, small capacity.
Rated output: 0.5kw.
Rated speed: 2000r/min.
Electromagnetic brake: No.
Oil seal: incidental (Note 1, note 2, note 3).
Power supply: 200V.
Note 1 through HG-KR and HG-MR series 0.1kW and HG-SR series can be supported.
Note 2 with the speed reducer case, do not configure the oil seal MITSUBISHI HA-LFS8014B.
Note 3 with oil seal HG-KR, HG-MR series servo motor''s appearance size standard is different.
Stable driving of medium capacity and medium inertia type products.
Through the optimization of structural design, to achieve the minimum length of the industry.
High speed & high torque MITSUBISHI Low inertia medium power motor. Shorten the positioning time, achieve high-speed equipment.
Reducing the electric torque ripple MITSUBISHI Low inertia medium power motor.
Through the combination of the optimal number of the motor and the slot number, the torque ripple is greatly reduced,
To further realize the smooth constant speed device.
Improve the environmental performance of HG-SR, HG-JR series of products using IP67. Drive: MR-H_ACN series CC-LINK features MITSUBISHI Low inertia medium power motor.
Rated output: 0.6KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And thhe measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive HA-LFS8014B.
Usually, such testing system is only used to test the rotational speeed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MITSUBISHI HA-LFS8014B.