MITSUBISHI D-20HC parts MITSUBISHI D-20HC

Input and output points: 1024 points.
Input / output data points: 1024 points.
Program capacity: 14K.
Basic command processing speed (LD command) s:0.20.
Coaxial data communication line function.
Each scanning process. Focus on the input signal sampling. Focus on the output signal to refresh.
Input refresh process MITSUBISHI D-20HC. When the input port is closed,
Program in the implementation phase, the input end of a new state, the new state can not be read D-20HC
Only when the program is scanned, the new state is read.
A scan cycle is divided into the input sample, the program execution, the output refresh.
The contents of the component image register are changed with the change of the execution of the program.
The length of the scan cycle is determined by the three MITSUBISHI D-20HC.
CPU the speed of executing instructions.
Time of instruction.
Instruction count.
Due to the adoption of centralized sampling.
Centralized output mode.
There exist input / output hysteresis phenomena, i.e., the input / output response delay.
User program storage capacity: it is a measure of how much the user application can store the number of indicators MITSUBISHI D-20HC.
Usually in words or K words as units. 16 bit binary number is a word,
Every 1024 words are 1K words. PLC to store instructions and data in words.
General logical operation instructions each account for 1 words MITSUBISHI parts. Timer / counter,
Shift instruction accounted for 2 words. Data operation instructions for 2~4. SUMINET-3200 network.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures MITSUBISHI parts.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
MITSUBISHI PLC protection and chain procedures.
Protection and chain is an indispensable part of the program, must be carefully considered.
It can avoid the control logic confusion caused by illegal operations MITSUBISHI parts. Memory card interface, serial interface.
On-line debugging is the process that will through the simulation debugging to further carry on the on--line unification to adjust D-20HC.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on stepp by step MITSUBISHI D-20HC.
If you do not meet the requirements, the hardware and procedures for adjustment.
Usually only need to modify the part of the program can be.