MR-J3ENSCBL2M-L Controller to amplifier bus cable MITSUBISHI MR-J3ENSCBL2M-L IP level: IP67 

Cable length: 1.0m.
Amplifier CC-Link interface unit cable.
For MR-J2S-11KA (4) MR-J2S-22KA to (4).
Amplifier and CC-Link interface unit using 0.5 m (1.64 ft) or shorter cables. Type: HA-ME series.
Rated output: 0.4KW.
Rated speed: 3000r/min.
Electromagnetic brake: there.
Control complex, easy to achieve intelligent,
The electronic commutation method is flexible and can be changed by square wave or sine wave MITSUBISHI MR-J3ENSCBL2M-L MR-J3ENSCBL2M-L
Motor maintenance free, high efficiency, low operating temperature,
Electromagnetic radiation is very small, long life, can be used in a variety of environments.
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
Synchronous machines are commonly used in motion control,
Its power range, you can do a lot of power MITSUBISHI MR-J3ENSCBL2M-L.
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction.
So it is suitable for the application of low speed and stable operation.
The rotor of the servo motor is permanent magnet,
Drive controlled U/V/W three phase electric electromagnetic field,
The rotor rotates under the action of the magnetic field,
At the same time the motor comes with the encoder feedback signal to the drive,
According to the feedback value and the target value, the driver is compared,
Adjust the rotor rotation angle MITSUBISHI MR-J3ENSCBL2M-L.
The accuracy of the servo motor is determined by the accuracy of the encoder MITSUBISHI Controller to amplifier bus cable. The length of the line: 2M.
IP level: IP65.
Cable lead out direction: motor shaft different side.
Bending life: high bending life MITSUBISHI Controller to amplifier bus cable.
The cable is not shielded.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). "1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 0.2kw.
Interface: SSCNET III /H.
Power supply: single phase AC100V power supply MITSUBISHI Controller to amplifier bus cable.
The servo amplifier is limited to 0.4kW.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system.
Not only inherited the original product of high performance and high reliability, but also made a further improvement beyond imagination.
MELSERVO-J4 grand debut.
Servo market for the star of tomorrow. World class servo products.
The new generation of MELSERVO should be what kind of? The answer to this question is already floating
Out of the water. MELSERVO-J4, it represents the whole digital, the original high performance based on an evolutionary.
Is also fully meet the reequirements of human beings and the environment MELSERVO latest masterpiece MR-J3ENSCBL2M-L.
For example, the safety and environmental requirements for the safety of human use and the safety specifications and "to Use Easy" design.
To meeet the needs of the environmental protection era of energy-saving performance MITSUBISHI MR-J3ENSCBL2M-L.
Beyond the performance of the evolution of MELSERVO-J4, shocking debut! "