XW2Z-200H-2 OMRON Connecting Cables for Connector-Terminal Block Conversion Units XW2Z-200H-2

Configuration: Covered Power Supplies.
Input voltage: 100 to 240 VAC (free) (80 to 370 VDC *).
S8JX-G15005@@:Switchable between 100 to 120 VAC and 200 to 240 VAC.
(DC power cannot be input.).
Power ratings: 50 W.
Output voltage: 12 V.
Output current: 4.2 A.
Built-in fan: No.
Easy-to-use, Widely range from 15 W to 600 W (Output Voltage: 5 V to 48 V) OMRON XW2Z-200H-2.
Easy Mounting: Front-mounted type, DIN rail-mounted type are available XW2Z-200H-2
Screw-mount at the top. (except 300-/600-W models).
Safety standards: UL 508/60950-1, cUL CSA C22.2 No. 107.1,
cUR CSA C22.2 No. 60950-1.
EN 50178 (= VDE 0160) Over voltage.
category III.
EN 60950-1 (= VDE 0805 Teil 1).
EMC: Conforms to EN 61204-3.
(EMI:EN55011 ClassA) OMRON XW2Z-200H-2.
Input conditions: The input voltage range of 15-W, 35-W,
50-W, 100-W, and 150-W models has,
been increased to 80 to 370 VDC (EC Directives and safety standards do not apply.).Cable: PVC.
Cable core number (core): 4.
Cable outlet direction: L type.
Cable length L:2m.
The province, province hours maintenance, use waterproof connector environment and strong tolerance of FA.
Conform to IP67 OMRON XW2Z-200H-2. FA small special connector flame retardant 94V-0.
The connector wiring system, convenient equipment maintenance, reduce equipment downtime.
IEC61076-2-101 (IEC60947-5-2).
For LED products, can clearly confirm the status of the sensor action. Type: 1 output.
Input power: 100/110/120V AC.
Detection, output form: voltage drop, power failure.
Power supply (commercial AC power supply) power cut detector for monitoring and control device OMRON Connecting Cables for Connector-Terminal Block Conversion Units OMRON Connecting Cables for Connector-Terminal Block Conversion Units.
Instantaneous detection voltage drop, power failure, instantaneous power failure.
Small, easy to install DIN guide rail mounting type.
Input voltage is divided into AC100V, AC200V two specifications. Sensor type and wiring: 2-wire DC 1-4/without polarity 3-4.
Actuator wiring: --.
No OMRON Connecting Cables for Connector-Terminal Block Conversion Units. of ports: 4.
No. of I/O: 4.
Simple Wiring of Sensor Actuators.
Greatly reduce wiring in combination with the Smartclick XS5.
Insert the connector and turn 1/8 of a turn to lock the connectors.
Higher rated current to ennable output applications XW2Z-200H-2.
Use previous M12 screw connectors. Model: P2RF (front-mounting), page 9.
Approx: 27 g.
Number of pins: 5 pins.
A Wide Variety of Square and,
Round Sockets in Front-mounting,
and Back-mounting Modelss,
Models available with finger protection OMRON XW2Z-200H-2.
Hold-down Clips and Socket Bridges for PYF Sockets,
are also available.
New screwless models available.