AC Servo MR-J2S-60B-PY096 INSTRUCTION MANUAL MITSUBISHI MR-J2S-60B-PY096 Manual

Drive: MR-H_ACN series CC-LINK features.
Rated output: 3.5KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MR-J2S-60B-PY096 INSTRUCTION MANUAL.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data MR-J2S-60B-PY096 Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J2S-60B-PY096 INSTRUCTION MANUAL.
Usually, such testing system is only used to test the rotational speed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive. Drive unit 200VAC/400VAC level.
MITSUBISHI motor general AC servo amplifier MELSERVO-J3 series MR-J2S-60B-PY096 INSTRUCTION MANUAL.
Need conversion unit MR-J3-CR55K) supporting the use of.
Rated output: 55kw.
Interface type: general pulse interface type.
Power specification: three phase AC400V.
Pulse train and analog input as universal interface MITSUBISHI MR-J2S-60B-PY096 Manual.
Can choose the position, speed and torque control mode.
The use of advanced tuning features such as advanced vibration suppression control and adaptive filter,
Greatly improve the performance of the machine MITSUBISHI MR-J2S-60B-PY096 Manual.
MR-J3, your partner.
Higher performance, more features, more convenient to use.
Highest performance in the industry.
Speed response frequency up to 2.1kHz. "MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series MITSUBISHI MR-J2S-60B-PY096 Manual.
Rated output: 3.5kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces thee routing time and helps to prevent noise MR-J2S-60B-PY096 .
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servvo amplifier, which can form the absolute value system MR-J2S-60B-PY096 INSTRUCTION MANUAL.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use. "