FX1N-14MR-ES/UL Manual MITSUBISHI FX1N-14MR-ES/UL HARDWARE MANUAL

Power: 11kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor MITSUBISHI FX1N-14MR-ES/UL HARDWARE MANUAL.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX1N-14MR-ES/UL
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor MITSUBISHI FX1N-14MR-ES/UL HARDWARE MANUAL.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Convert connector to screw relay terminal.
According to the location of the connection equipment distribution module. Power: 55kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load) MITSUBISHI FX1N-14MR-ES/UL HARDWARE MANUAL.
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Memory format: EPROM.
Number of steps:
Can use up to 16000 steps.
Battery support: do not.
Method of writing and deleting: write and use ROM to write, use ultraviolet ray to delete. MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 18.5KW.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
Such as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be operatted at high precision in the super low speed region without the need of the encoder FX1N-14MR-ES/UL Manual.
With torque control mode,
And in the speed control mode can use the torque limit function.
With vector control function (with encoder),
Frequuency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc FX1N-14MR-ES/UL Manual. ) and torque control.