INVERTER FR-A741-5.5K to 55K Applied Manual MITSUBISHI FR-A741-5.5K to 55K INSTRUCTION MANUAL

Maximum frequency: 50kHz.
Input points: 1 points.
Output form: transistor 2 point output.
Weight: 0.13kg.
FX2NC-1HC can achieve high speed counting by 1 phase /2 phase 50kHz hardware counter.
Hardware comparator with high speed matching output function.
In the 2 phase count, can be set 1, 2, 4 frequency FR-A741-5.5K to 55K Manual.
Can be achieved by PLC or external input to count the licensing / prohibition FR-A741-5.5K to 55K
Can also be connected to the linear drive output type of the encoder.
FX2NC-1HC can only be connected to FX3UC. Can be used as a screw relay terminal.Total points: 30 points.
Input points: 16 points.
Output points: 14 points.
Voltage: AC220V.
Output type: relay.
Outline dimension: 100*75*90.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 FR-A741-5.5K to 55K Manual.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment. Input / output type: DC input (drain / source).
Input points: 8 points FR-A741-5.5K to 55K Manual.
Input and output points: 8 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms MITSUBISHI FR-A741-5.5K to 55K INSTRUCTION MANUAL.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis MITSUBISHI FR-A741-5.5K to 55K INSTRUCTION MANUAL.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect MITSUBISHI FR-A741-5.5K to 55K INSTRUCTION MANUAL.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNNV-IF or FX3UC-1PS-5V FR-A741-5.5K to 55K Applied.
The number of connection points depends on the basic unit and the expansion unit. Analog input expansion board (2 channel).
Can be installed in FX1N, PLC FX1S, providing 2 channel analog input of thee board FR-A741-5.5K to 55K Manual.
Because it is embedded in the PLC installation, so do not need to install space.
Can be mixed with the use of voltage input and current input.