MITSUBISHI Q02CPU Programming Manual CPU Common Instructions 1/2 Manual

8 channel.
Input: DC-10~10mA; 0~20mA.
Output (resolution): 0~4000; -4000~4000; 0~12000; -12000~12000; 0~16000; -16000~16000.
Conversion speed: 10ms/ channel.
40 pin connector.
Isolation between channels.
The possibility of expanding control with intelligent function.
At the same time, the channel isolation analog module realizes high isolation voltage,
Further improve the accuracy of the benchmark Q02CPU Manual Q02CPU
Provide support for process control using a general purpose programmable controller.
Flow meter, pressure meter, other sensors can be directly connected to analog input,
Control valve can also be directly connected to analog output.
Hardware and installation costs have been greatly reduced due to the need for an external isolation amplifier Q02CPU Manual.
High insulation strength.
Can isolate electrical interference, such as current and noise, etc..
Standard analog input module.
Isolated analog input module.
No external isolation amplifier required.
Without the use of inter channel isolation analog modules.
Using the inter channel isolation analog module.Master station module supporting AnyWireASLINK system Q02CPU Manual.
Connecting sensor and programmable controller.
Free configuration of sensors, control of 512 points of the input and output.
The AnyWireASLINK transmission line (2 lines) can be used for communication to supply power for the sensor, and the sensor can also be conveniently added MITSUBISHI CPU Manual.
Can through the project software GXWorks2 batch management sensor shedding detection and from the station module settings, etc MITSUBISHI CPU Manual. ,
Substantial savings in time and cost.Control axis: maximum 8 axes.
Greater flexibility.
PLC control and motion control using independent CPU, optimize the system configuration.
More than 4 CPU modules can be freely selected in multi CPU system.
MITSUBISHI SSCNET control function MITSUBISHI CPU Manual.
By using the high speed serial communication mode, we can easily construct the synchronization system of the servo motor.
The motion conttroller and the servo amplifier can be quickly connected by a connector, and the connection is simplified Q02CPU Programming Manual .
Each 1 CPU can control up to 32 axes at the same time.
Can control the small capacity from 10W to 55KW large capacity servo motoor Q02CPU Manual.
Through the use of digital oscilloscope function, can be used to control the power distance, speed, position and other motor information monitoring.