Silicon controlled output module AJ35PJ-8S1 datasheet PDF catalog MITSUBISHI AJ35PJ-8S1 PDF datasheet

Optional features of memory card (Q/QnA/A/FX compatible).
8MB extended memory.
Applicable models: A985 (-V) /975/970/A960GOT (-B) /A956WGOT. 10BASE-T.
For Q mode.
Control layer /MELSECNET/10 (H) is the middle layer of the whole network system,
Control network which is convenient and high speed processing data transmission between PLC, CNC and other control equipment AJ35PJ-8S1 PDF catalog .
As MELSEC control network MELSECNET/10,
With its good real-time performance, simple network settings, no procedures of the network data sharing concept,
As well as the redundant circuit and so on, has obtained the very high market appraisal,
The number of devices to reach the highest in japan,
In the world is also one of the few AJ35PJ-8S1 PDF catalog AJ35PJ-8S1
And MELSECNET/H not only inherited the excellent characteristics of MELSECNET/10,
Also makes the network real-time better, more data capacity,
Further adapt to the needs of the market. Enter 64 points.
Above DC7V.
Response time: 16ms.
16 pin connector.
Output 64 points.
Response time: 16ms.
32 pin connector dynamic input and output data.
PLC is introduced by the relay control technology after the development of micro processing technology,
Can be easily and reliably used for switching control AJ35PJ-8S1 PDF catalog .
As the analog quantity can be converted into digital quantity, the number of digital quantity is just a number of switching value,
Therefore, after the conversion of analog, PLC can also be reliable for processing control MITSUBISHI AJ35PJ-8S1 PDF datasheet.
Because the continuous production process often has the analog quantity, the analog quantity control is sometimes called process control MITSUBISHI AJ35PJ-8S1 PDF datasheet.
Analog quantity is not electricity, and PLC can only handle digital quantity, quantity of electricity.
All to realize the conversion between them to have the sensor, the analog quantity into a number of power.
If this power is not standard, but also through the transmitter,
The non-standard power into a standard electrical signal, such as 1-5V, 4-20mA, 0-10V, etc MITSUBISHI AJ35PJ-8S1 PDF datasheet. .
At the same time, there is also an analog input unit (A/D),
Transform these standard electrical signnals into digital signals,
The analog output unit (D/A), in order to transform the digital quantity after PLC processing into analog quantity -- standard electric signal AJ35PJ-8S1 datasheet.
So the standard telecommunication number, the conversiion between the number of operations to use a variety of computing AJ35PJ-8S1 PDF catalog .
This requires the resolution of the analog unit and the standard electrical signal.