amplifier MR-JE-40B datasheet PDF datasheet MITSUBISHI MR-JE-40B PDF catalog

Drive: MR-H_ACN series CC-LINK features.
Rated output: 1.0KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MR-JE-40B PDF datasheet .
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data MR-JE-40B Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-JE-40B PDF datasheet .
Usually, such testing system is only used to test the rotational speed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive. The length of the line: 5M.
Relay type.
IP level: IP20 MR-JE-40B PDF datasheet .
Bending life: standard.
Encoder with cable (amplifier side); for HF-KP/HF-MP series. The length of the line: 5M.
IP level: IP65.
Bending life: standard.
The cable is not shielded.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction) MITSUBISHI MR-JE-40B PDF catalog. Power: 75kw.
Voltage: 200V.
Sine wave filter.
The voltage and current of the motor can be adjusted to a sine wave MITSUBISHI MR-JE-40B PDF catalog.
The sine wave filter is installed to the output terminal of the inverter.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter.
Sine wave filter is equivalent to the operational characteristics of the sine wave power driver, can provide the following benefits MITSUBISHI MR-JE-40B PDF catalog.
Low noise.
No surge current.
Reduce motor loss (standard motor). MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 7.0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for direct drive servo motor.
Power specification: three phase AC200V.
Direct drive system suitable for high speed and high precision!
High speed operation can be realized by direct drive (2m/s), and the traditional mechanical transmission can not achieve such a high speed.
The full closed loop control can be realized by using the position feedback signal from the load side encoder, such as the linear encoder.
The use of a flexible linear servo motor drive components can make the sysstem more compact structure MR-JE-40B datasheet.
The primary side of the linear servo motor (motor coil) is sliding along the secondary side (permanent magnet) of the motor,
So linear servo motor is especially suitable for large range of appliccations MR-JE-40B PDF datasheet . In addition, linear servo motor can be connected in series,
Especially for large systems in two axes for high precision synchronous operation.