C200HG-CPU43-E HOST CONNECTION MANUAL OMRON C200HG-CPU43-E Manual

C200HS-CPU33-E CPU
High-Performance CIM Version, Built-in RS-232C Port
The C200HS-CPU31-E and C200HS-CPU33-E controller offers the same basic functionality as the C200HS-CPU01-E/CPU03 controllers.
This CPU may be used ineither SYSMAC NET and/or SYSMAC LINK communication systems.
The built-in RS-232C port supports the same communications as the C200HS-CPU21/CPU23 OMRON C200HG-CPU43-E Manual. Name: e-CON Connectors C200HG-CPU43-E
Specifications: Inputs; 32 inputs; NPN;
With Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system OMRON C200HG-CPU43-E Manual.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Name: Three-tier Screw Terminal Block.
Specifications: Outputs; 8 outputs; PNP;
With Short-circuit and,
Disconnected Line Detection OMRON C200HG-CPU43-E Manual.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Unit type: CS1 CPU Bus Units.
Product Name: MECHATROLINK-II,
compatible Position Control Unit.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder,
programming, Control mode:
Position control, speed control,
or torque control; No. of axes: 2.
No. of unit numbers allocated: 1.
CCurrent consumption: 5V, 0 C200HG-CPU43-E HOST CONNECTION MANUAL. 36A; 26V, --.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes,
in a motion networkk with one Position,
Control Unit that supports MECHATROLINK-II C200HG-CPU43-E HOST CONNECTION MANUAL.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.