CA3-ISO232-01 Manual Proface CA3-ISO232-01 User's Manual

For 5.7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening.15 inches, replaced by a host of backlight (1).COM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)For 3 Proface CA3-ISO232-01 User's Manual. 8 inch models, prevent cable loose from the USB cable fastening clip (5 / set) CA3-ISO232-01COM2 terminal adapter for communication through the RS-422/485 connectionConnect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM2Protection for GP rear connectors (large and small for each of the 1).Expansion module for the GP3000 access to the DeviceNet network and communication with the DeviceNet master station12 Proface CA3-ISO232-01 User's Manual. 1 inches /10.4 inches (STN), the GP installed to the hard panel to provide dust and moisture proof function.Engineering documents created by the LT interface to download images and logic programming software through the USB interface.7.5 inches, GP installed to the hard panel to provide dust and moisture proof function.13 pin input connectors for HTB and 16 pin output connectors Proface CA3-ISO232-01 User's Manual. (1 / set)12.1 inches, replaced by a host of backlight (1).The host controller is connected to the host computer interface, which is used for multiple connection (n:1) communication.For 5.7 inch models, for fixing the hooks of the three EX modules.Fitting on NETWORK FLEX interface. Connecting NETWORK FLEX communication cable. (5 / set)Adapter for EX module (5 / set)For the operation screen (5 pieces) (GP3000H standard).1GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.COM1 pin adapter, which is used to connect the communication components that are dedicated to the COM2 interface to the COM1 interface of the man-macchine interface CA3-ISO232-01 Manual. COM1 interface with the cable for direct connection to the CPU series PLC A2GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memoory card CA3-ISO232-01 Manual. Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.Slave station module for connecting support for CANopen