15 inches, replaced by a host of backlight (1).USB cable clamp for preventing disconnection of connection (5 / set)13 pin input connectors for HTB and 16 pin output connectors. (1 / set)256MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface SMART SENSORS User's Manual. The main controller is connected to the man-machine interface for MPI communication10
CA4-ATM5-014 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.For 3.8 inch models, prevent cable loose from the USB cable fastening clip (5 / set).10.4 inches (TFT), for the protection of the man-machine interface from oil and chemical pollution (5 / set) Proface SMART SENSORS User's Manual. Used to convert the USB interface to the serial interface (RS-232C). A modem or bar code reader that can be connected to support RS-232C.15 inches, GP installed to the hard panel to provide dust and moisture proof function.COM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connection10 Proface SMART SENSORS User's Manual. 4 inches (TFT), the replacement of the host backlight (1).10.4 inches and above, used to connect the power cord (5 / set).Used to convert RGB to DVI-A12.1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set) CA4-ATM5-01 User's Manual. COM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)12 CA4-ATM5-01 User's Manual. 1 inches, replaced by a host of backlight (1).5.7 inches, for the protection of the man-machine interface from oil and chemical pollution (5 / set).GP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelCOM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connector10 CA4-ATM5-01 User's Manual. 4 inches (TFT), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set) CA4-ATM5-01 Manual. A connector that connects the DIO interface for connecting an external I/O deviice (5 sets) Proface SMART SENSORS User's Manual. Protection for GP rear connectors (large and small for each of the 1).Extension cable for connecting USB (Type-A) interface to front panel.