GX-ID1628 Manual OMRON Analog I/O Units GX-ID1628 PROGRAMMING MANUAL

Number of phase: Single-phase.
Control terminal block: Screwless clamp terminal block.
Type: Constant current.
Capacity: 60 A, 100 to 240 VAC.
Heater burnout detection: Yes.
Communications: Yes.
High-precision Control with Easy Setup,
Precise heater burnout detection.
Set value and present value monitoring with indicators OMRON Analog I/O Units PROGRAMMING MANUAL.
Phase control or optimum cycle control GX-ID1628
RS-485 communications to set manipulated variables and,
monitor load current.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,
and constant-current control.
Application with various loads: constant load resistance,
variable load resistance OMRON Analog I/O Units PROGRAMMING MANUAL.
UL, and IEC/EN (TÜV) certified. Terminal (Wire connection): Screw terminal.
Classification: Microloads.
Latching lever (Test switch): No.
Rated input voltage: DC, 12V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel.
Realized opening and closing ability with one pole 6 A slim shape OMRON Analog I/O Units PROGRAMMING MANUAL.
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location) GX-ID1628 PROGRAMMING MANUAL.
Screw terminal is also stocked to meet the screw type needs GX-ID1628 PROGRAMMING MANUAL.
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Standard certification: No.
Action indicator: there.
Applicable load of output: AC100 3A ~ 240V.
Input rated voltage: DC12V.
Insulation mode: three end two-way photoelectric switch GX-ID1628 PROGRAMMING MANUAL.
Zero trigger function: No.
And the MY type of the same shape of the G3F series of new international standard certification (-VD type).
Achieved UL, CSA, EN (VDE certification) standard certification. (type -VD)
Socket terminal type of same size with MY (2 pole type).
A model with an action indicator to check the status of the input. Number of phases: Single-phase.
Insulation method: Phototriac coupler.
Operation indicator: Yes (yellow).
Rated input voltage: 12 to 24 VDC.
Zero cross function: No.
Applicable load: 35 A, 100 to 240 VAC.
Compact, Slim-profile SSRs with Heaat,
Sinks GX-ID1628 Manual. Models with No Zero Cross for,
a Wide Range of Applications.
RoHS compliant.
Models also available with no zero cross,
Surge pass protection improved surge dielectric strength for,
output cuurrents OMRON Analog I/O Units PROGRAMMING MANUAL. (OMRON testing).
Compact with a slim profile.
Mount to DIN Track or with screws.
Conforms to UL, CSA, and EN standards (TÜV certification).