MITSUBISHI MR-J3-700B-RJ080W For direct drive servo motor drive

MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 0.6kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0 MR-J3-700B-RJ080W.888ms.
> Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller MR-J3-700B-RJ080W.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system MITSUBISHI MR-J3-700B-RJ080W.
This simple connection method reduces the routing time and helps to prevent noise MR-J3-700B-RJ080W.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system MITSUBISHI MR-J3-700B-RJ080W.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.Cable length: 1mThe length of the line: 2M.
IP level: IP65.
Direct type.
Bending life: high bending life.
The cable is not shielded.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction) MITSUBISHI MR-J3-700B-RJ080W. The length of the line: 2M.
IP level: IP65.
Cable outlet direction: the same side of the motor shaft.
Bending life: standard.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Fiber length: 40 meters MR-J3-700B-RJ080W.
SSCNET III cable (long distance optical fiber, high bending life).
Joints for CN1A and CN1B. Specification: allowed regeneration power: 300W, resistance value: 40 ohm.
Uses: MR-JE-70B, MR-JE-100B, MR-JE-70A, MR-JE-100A with.