A9GT-50WRS4 MITSUBISHI A9GT-50WRS4

Type: MR-J series.
Rated output: 0.75KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control A9GT-50WRS4
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment MITSUBISHI A9GT-50WRS4.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor.
Encoder serial communication system, the communication frequency can only be limited to 10M. According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program MITSUBISHI A9GT-50WRS4.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system .
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc.. "Total input and output points: 16 points.
Input points: 16 points.
Output type: DC24V.
FX2N extension module.
The expansion module is an input and outpuut expansion devvice of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect A9GT-50WRS4.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When coonnecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V A9GT-50WRS4.
The number of connection points depends on the basic unit and the expansion unit.
A9GT-50WRS4 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=A9GT-50WRS4&select=5