MITSUBISHI R60TCTRT2TT2BW R60TCTRT2TT2BW

Program 2 channel connection, AnCPU/QnACPU use.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
MITSUBISHI PLC protection and chain procedures.
Protection and chain is an indispensable part of the program, must be carefully considered MITSUBISHI R60TCTRT2TT2BW.
It can avoid the control logic confusion caused by illegal operations R60TCTRT2TT2BW Motor series: medium inertia, medium power.
Rated output power: 1.0kw.
Rated speed: 2000r/min.
Whether to take the brake: No.
Shaft end: Standard (straight).
Power supply: 400V type MITSUBISHI R60TCTRT2TT2BW.
Protection level: IP65 (IP67).
Features: medium inertia from low speed to high speed three modes for selection, suitable for different applications .
Application examples: transmission machinery, robots, X-Y working platform.
High resolution encoder 131072p/rev (17 bit).
The encoder with high resolution ensures excellent performance and stability at low speed.
All motor dimensions are the same as before and all are compatible with the wiring MITSUBISHI R60TCTRT2TT2BW. 5 slots.
Can be installed in the power supply unit for A series units installed QnA/ .
Relay output interface circuit of PLC
Working process: when the internal circuit output digital signal 1,
There is a current flowing through, the relay coil has a current, and then the normally open contact is closed,
Provide load current and voltage.
When the internal circuit outputs a digital signal 0, there is no current flowing through it,
The relay coil does not have a current, and the normally open contact is broken off,
A current or voltage that is disconnected from the load.
It is through the output interface circuit to the internal digital circuit into a signal to make the load action or not action.
I/O points is an important indicator of PLC.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest.
The input and output points and types of PLC should bee determined accordding to the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point R60TCTRT2TT2BW.
Taking into account the future adjustment and expansion,
In general should be estimaateed on the total number of points plus the amount of spare 20%~30% R60TCTRT2TT2BW.
The following describes the centralized control system I/O points of the estimate.
R60TCTRT2TT2BW Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=R60TCTRT2TT2BW&select=5